SMR Gearbox Set up
Satisfactory functionality is determined by correct installation. lubrication and servicing. for that reason it’s important the directions while in the set up and servicing leaflet. provided with each gearbox. are followed thoroughly. a number of the critical facets of belt and torque-arm set up are listed beneath.
one. Install pulley on gearbox input shaft as close on the reducer doable, and mount reducer on driven shaft as near to bearing as practical. failure to try and do this will result in extra loads within the input shaft bearings and output bearings and could lead to their premature failure.
2. Install motor and wedge belt drive using the belt pull at somewhere around 90° on the center line amongst driven and input shafts. this can allow tensioning with the wedge belt drive using the torque arm which really should preferably be in tension. if output hub runs anti-clockwise. torque arm ought to be positioned the correct.
3. lnstall torque-arm fulcrum on the rigid support so that the torque-arm will likely be at around proper angles to the center line through the driven shaft plus the torque arm case bolt. ensure there’s sufficient get up during the turnbuckle for belt stress adjustment.
Continue to keep close.
Bell drive can be positioned in any easy postion. when the torque arm is usually to be utilised to tighten the belts, the drive need to be at about tight angle to your line concerning the input and output shafts.
Bell drive can be situated for the proper if desired.
If output hub rotates clock-wise. place belt drive and torque arm in opposite course to that shown from the illustration.
Torque arm and belt get up.
Torque arm may be mounted towards the suitable if desired.