Materials Handling Power UNIT 1
Common Description
This energy unit is built for your fork lift marketplace, consisting of hugely effective gear pump, DC motor, guide raise and reduce valve, tank, ect. The up and down motion are managed through the lever from the manual release valve, that’s outfitted with an electric switch to activate the motor. The lowing velocity is managed through the strain compensated flow handle valve.
Specific Notes
one. The duty of this energy unit is S3, i.e. 30 seconds on and 270 senconds off.
2. Clean all of the hydraulic parts concerned before installation of the energy unit.
three. Viscosity on the hydraulic oil shoud be 15~46 cst, which must also be clean and no cost of impurities, N46 hydraulic oil is suggested .
4. Oil shifting is required right after the original one hundred operation hours, afterwards after every single 3000 hours.
five. The power unit shown is intended to be mounted horizontally.

Material Managing Energy UNIT 2
General Description
This electrical power unit attributes power up gravity down circuit. Activate the get started solenoid to start the motor to lift the machine. The lowing movement is activated through the solenoid valve together with the decreasing pace managed from the stress compensated movement handle valve. Solutions of this series might be broadly used in the field of logistic products for instance fork lift, mini lift table, etc.
Special Notes
one. The duty of this electrical power unit is S3,i.e.,30 seconds on and 270 senconds off.
two. Clean each of the hydraulic elements concerned ahead of mounting the power unit.
3. Viscosity on the hydraulic oil shoud be 15~46 cst,which really should also be clean and no cost of impurities, N46 hydraulic oil is encouraged .
4. Oil shifting is required right after the original one hundred operation hours,afterwards once each 3000 hours.
5. The power unit should be mounted horizontally.