Energy UNITS FOR LIFT TABLE one
Standard Description
This energy unit is developed solely for your modest lift table,Consisting of higher strain gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This electrical power unit has become extensively employed from the sector of logistic gadgets for example minifork lift, scissors lift and ariel doing work platforms. The lower-ing motion is managed by the solenoid valve using the velocity managed by the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
Basic Description
This power unit is made solely to the medium lift table, Consisting of very effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing motion is actived through the solenoid valve and the velocity managed by the adjustable needle valve. When the lift rises to a higher positoin, however the energy supply is cut, the lowering motion is controlled through the manual override perform.
Electrical power UNITS FOR LIFT TABLE 3
Common Description
This power unit is built solely for that substantial lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived from the solenoid valve and the pace controlled by a strain compensated movement management valve.
Energy UNITS FOR LIFT TABLE 4
Basic Description
This power unit is built solely to the large lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived by the solenoid valve as well as velocity managed by the adjustable needle valve. Once the lift rises to a higher positoin, but the energy provide is reduce, the decreasing motion is managed by the guide override perform.
Exclusive Notes
1. This electrical power unit is of S3 duty cycle, which may only do the job intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean all of the hydraulic elements concerned ahead of set up of the energy unit.
3. Viscosity on the oil shoud be 15~46 cst,which really should also be clean and cost-free of impurities.N46 hydraulic oil is suggested.
four. Oil transforming is required soon after the first 100 operation hrs,afterwards once every 3000 hours.
5. The electrical power unit proven is built to be mounted vertically.